Advertisement
Service Information S170
You may have a complaint about the S170 initialising. This may
be due to the power supply connector pins making poor contact.
To improve contact between the power supply and the pc board
perform the following .From the connector marked X27 ,the wires will have
to be soldered directly to the pins on the pc board . This is a 6 pin connector
with only 5 wires used. Unplug the connector from the board and cut the
wires from the connector. Strip and solder each power supply wire to its
corresponding pin labelled on the pc board. See diagram 1. Use heat shrink
tubing to prevent shorting the wires when soldering to the pins on the pc
board . I f the unit is received for general service this procedure should be
carried out.
Diagram 1
!
THIS AREA OF THE
POWER SUPPLY DO NOT TOUCH.
+5v adj.
ww
Contact:
NAD Electronics International
633 Granite Court
Pickering, ON Canada L1K 3K1
Voice: 905-831-0799 FAX 905-837-6357
www.nadelectronics.com
Cut wires here
Strip and solder to pc board connector
Red wire
Green wire
Green wire
Gray wire
Yellow wire
CONNECTOR
X27
MAIN
PC BOARD
DGND
+5v
-15v
AGND
+15V
AGND
Advertisement
Table of Contents
Related Manuals for NAD S170
Summary of Contents for NAD S170
- Page 1 Service Information S170 You may have a complaint about the S170 initialising. This may be due to the power supply connector pins making poor contact. To improve contact between the power supply and the pc board perform the following .From the connector marked X27 ,the wires will have to be soldered directly to the pins on the pc board .
- Page 2 Service Information S170 You may have a complaint about the S170 initialising. This may be due to the power supply connector pins making poor contact. To improve contact between the power supply and the pc board perform the following .From the connector marked X27 ,the wires will have to be soldered directly to the pins on the pc board .
Need help?
Do you have a question about the S170 and is the answer not in the manual?
Questions and answers