Advertisement
Connect the RVL Transmitter
The following table identifies the input/output (I/O) ports on the front of your RVL transmitter
Table 1 - RVL Transmitter I/O Port Locations and Ground Screw
View of Unit from Front
1
2
(1)
The USB ports are not for use in hazardous locations. Only use the USB ports for initial setup and maintenance.
.
• Your DC powered RVL transmitter requires a safety extra low voltage (SELV) power supply. The internal power supply is protected against reverse polarity.
• To minimize ground loop currents and noise, we recommend that your DC powered RVL transmitter uses only one grounded connection.
See
Install the Ground Wire on page 6
Assemble the DC Terminal Block Kit
The connector assembly provides strain relief for the DC power wires by reducing their movement. To assemble and attach the DC terminal block kit:
IMPORTANT
The DC terminal block in the photos is only for illustrative purposes. Your DC terminal block can differ in size, shape, and color to what is shown
in the photos.
DC Power Connector Assembly Steps
Table 2 - DC Terminal Block Connection Specifications
5
3
1
2
3
5
Figure 3 - DC Terminal Block Assembly Steps
A
1.
Open the DC terminal block (supplied) (A in
2.
Insert the cable tie through the slots of the appropriate connector clamp (B in
3.
Strip the end of each DC power wire to the length in
IMPORTANT
DC power wires must be of stranded copper and sized according to
4.
Insert each stripped end into the DC terminal block as shown in
5.
Tighten the screws on top of the DC terminal block to secure the DC power wires to the torque value in
6.
Slide the connector half with the attached cable tie onto the end of the DC terminal block (C in
7.
Tighten the cable tie so it is snug against the terminal wires.
8.
Use cutting pliers to cut the excess cable tie (D in
9.
Install the white label supplied with the kit (E in
The white label can be used for identification or other information.
Remote Video Link Transmitter for 6300B Box PCs and 6300T Box Thin Clients Installation Instructions
Note No.
1
3
2
3
5
4
4
5
for the ground connection on these models.
Note No.
4
4
B
C
Figure
3).
Table
2.
Table
2.
Figure
3).
Figure
3).
Rockwell Automation Publication 6300V-IN005A-EN-P - November 2022
Component/Cable Type
RVL In
DVI-D Output
(1)
USB 2.0
24V DC Power
Ground Screw
Description
1
DC+ (24V DC nominal) recommended power wire size
2
DC- (0V DC) recommended power wire size
3
Stripped wire length
4
Torque range to secure DC power wires
5
Torque value to reinstall DC terminal block to computer
D
E
Figure
3).
Table 2
Table
2.
Figure
3).
Attribute
2
1.5 mm
(16 AWG)
2
1.5 mm
(16 AWG)
7 mm
(0.275 in.)
0.22...0.25 N•m
(0.16...0.18 lb•ft)
0.3 N•m
(0.22 lb•ft)
G
F
Ground
Screw
5
Advertisement
