2-8.
CAPSULE HOLDER (25), REFLECTOR
guide line (edge)
–
reflector
6 reflector
Note 4: When installing the reflector,
align the rib and slide switch.
3 screw (M1.7) (L = 4.0 mm)
Note 3: When tightening screw, tighten
the below torque value.
tightening torque:
2 capsule holder (25)
(See Fig. F)
capsule side
1 arock precision screw (P2.6
Note 1: When removing screw, it is not reused.
Be sure to replace them with new parts.
Note 2: When tightening screw, tighten
the below torque value.
tightening torque:
When installing the capsule holder (25), align the shape
of the capsule suspension and the screw holes.
capsule
holder (25)
capsule
suspension
sheet (SW)
capsule
–
side
5 sheet (SW)
5 sheet
(SW)
5)
–
–
–
–
SIDE-001 board side
rib
4 Remove the reflector block
in the direction of the arrow.
5 sheet (SW)
3 screw (M1.7) (L = 4.0 mm)
Note 3: When tightening screw, tighten
the below torque value.
tightening torque:
guide line (edge)
sheet (SW)
reflector
–
C-100
screw hole
screw hole
connector side
slide switch
guide line (edge)
sheet (SW)
capsule side
–
11