Nova 8345-R Manual

HOW TO
ASSEMBLE YOUR
Toilet Seat Riser - Hinged
Item #'s 8345-R /8346-R
Capacity not to exceed 300 lbs.
1
Remove all parts from box:
One seat, 2 mounting screws, 2 washers and 2 wing nuts
Clean and sanitize toilet seat.
2
Remove the existing toilet
seat and lid from the toilet
frame by unscrewing the seat
screws located at the rear of
the seat.
4
Replace the toilet seat and
lid so the mounting holes of
the toilet seat, the elevator
and the frame line up. Place
washer onto screw. Insert
the mounting bolts with
washer through top of the
seat, seat elevator, and toilet
frame.
Questions?
Please contact us at
1-800-557-6682
info@novamedicalproducts.com
Thank you for choosing NOVA!
IMPORTANT WARNING
READ THESE DIRECTIONS CAREFULLY BEFORE USE.
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.
• Be sure seat is in place and secure before each use.
• Do not stand on seat.
3
Place the toilet seat elevator on the
toilet frame. The mounting holes on
the rear of the elevator should line
up with the mounting holes on the
rear of the toilet frame.
5
Attach the provided wing nuts to
each mounting screw. Do not tighten
completely. Be sure the toilet seat is
straight and sits flush on the seat
and then fully tighten the wing nuts.
6
To raise elevator seat lift using side
openings
No tools required
Quick Assembly
Follow these
SIMPLE STEPS
Connect with us!
novamedicalproducts.com
facebook: novamedicalprod
twitter: novamedicalprod
twitter: novawalkerstalk
pinterest: novamedicalprod