Advertisement
I
nstallation
The product must be installed and maintained
by a
with latest building/construction and/or electrical
regulations and relevant legislation.
Warning:
installing and connecting the luminaire.
Notice:
than the original manufacturer, then the warranty
will no longer be valid and shall become the full
responsibility of the modifying person/organisation.
Claims based on defects attributable to improper
installation and/or application, and the consequences
thereof, are excluded.
Installation Procedure – QLS410/QLS420 LED
loosening screws C.
3. Check that rating shown on luminaire label
conforms with mains electrical supply.
4.
Drill relevant holes E and insert wall plugs F.
Warning: Ensure not to damage any electric
cable, water pipe or other devices while drilling
holes. Fixture is intended to be mounted over a
UL listed junction box (not supplied by WE-EF),
use provided wall plate to cover boxes larger
than the outer dimensions of the luminaire.
5. Feed the mains supply cable G (and the second
cable for through wiring, if required) through
the pressure screw I
The pre-installed packing ring H is suitable for
is bigger, replace the pre-installed packing ring
with the supplied auxiliary packing ring, which is
6. Ensure the point arrow mark R
aims upwards and that the luminaire is properly
tightening screws D.
terminals in terminal block J:
a) ON/OFF (L = Phase, N = Neutral,
D–
8. Tighten pressure screw(s) I.
9. Reposition cover B
position by evenly tightening the screws C.
3
A from cover B by
D.
= Earthing)
= Earthing,
A and secure in
Advertisement
