Table of Contents
Advertisement
Lafayette Hand-held Dynamometer
Resets
To restore an HHD to factory defaults, press MENU/SELECT and navigate to the Information screen.
Press and hold MENU/SELECT then press the upper left button consecutively until screen reads
"Factory reset will delete all tests and all settings". Follow the prompts on screen until the screen reads
"Factory reset complete!".
Hard Reset: If the HHD freezes press lower down arrow and the upper right button until the unit
Firmware Updates
download our Firmware Updater software. The Hand-held Dynamometer can be updated by plugging
Firmware Updater.
Dynamometer Cleaning
Hard surfaces can be cleaned with a bleach-free sanitizing wipe. Alcohol wipes may also be used.
Cloth or foam surfaces can be cleaned with anti-bacterial soap and water and allowed to air dry. Care
must be taken to not allow water to penetrate the enclosure as damage to the circuit may occur.
Disposable sanitary covers are available on the stirrup pad that comes into direct contact with the
patient's skin. Do not reuse disposable covers.
Disclaimer: These cleaning instructions for Lafayette Instrument products are a recommendation of
compatible cleaning materials only. Product end users are responsible for instituting an appropriate
cleaning regimen utilizing best practices and techniques. Lafayette Instrument assumes no
responsibility for the cleanliness or sanitation of the products after initial use nor makes any claim that
the use of the recommended cleaning materials mitigates all risk of potential cross infection.
3700 Sagamore Pkwy Lafayette, IN 47904 USA . Phone: (765) 423-1505
10
Advertisement
Table of Contents
