Advertisement
RS485 Modbus
JXBS-3001-PH-RS Soil PH Sensor User Manual
After opening the software, first select the "Sensor Type" at the top of the
software, then obtain the serial number and select the correct serial port
according to the method in section 3.1.1, and then click "Automatically obtain
the current baud rate and address" to automatically detect All devices and
baud rates on the 485 bus. Please note that there is only one sensor on the
485 bus when using software for automatic acquisition. Then click "Connect
Device" to get sensor data information in real time.
3.1.3 Modify Baud Rate & Device Address
In the case of disconnecting "device connection", click "modify baud rate and
modify slave station number" in "configure sensor communication parameters"
to complete the relevant settings. Please note that after setting, please restart
the device, and then "automatically obtain the current "Baud Rate and
Address", you can find that the address and baud rate have been changed to
the address and baud rate you need.
IV Communication Protocol
4.1 Basic Specs
6 / 8
Advertisement
