Craftsman PGT9000 Operator's Manual page 26

Leveling the Deck (Side to Side)
If the cutting deck appears to be mowing unevenly, a side to side
adjustment can be performed. Adjust if necessary as follows:
1. With the tractor parked on a firm, level surface, place the deck lift
lever in the top notch (highest position) and rotate both blades so
that they are perpendicular with the tractor.
2. Measure the distance from the outside of the left blade tip to the
ground and the distance from the outside of the right blade tip to
the ground. Both measurements taken should be equal. If they're
not, proceed to the next step.
3. Loosen, but do NOT remove, the hex bolt on the left deck hanger
bracket. See Figure 23.
Adjustment
Gear
4. Using a wrench, raise or lower the left side of the deck by turning
the adjustment gear. See Figure 23.
The deck is properly leveled when both blade tip measurements
taken earlier are equal. Retighten the hex bolt on the left deck hanger
bracket when proper adjustment is achieved.
Parking brake Adjustment
If the tractor does not come to a complete stop when the brake pedal
is completely depressed, or if the tractor's rear wheels can roll with the
parking brake applied (and the hydrostatic relief valve open), the brake
is in need of adjustment. See a Sears or other qualified service dealer
to have the brake properly adjusted.
Adjusting the Seat
Refer to the Assembly section of this manual for seat adjustment
instructions.
WARNINg
Before operating the tractor, make sure the seat is engaged in the
seat-stop. Engage the parking brake. Stand behind the machine and
pull back on seat until it clicks into place.
SErVICE And MAInTEnAnCE
Hex Bolt
Figure 23
Steering Adjustment
If the tractor turns tighter in one direction than the other, or if the ball
joints are being replaced due to damage or wear, the steering drag
links may need to be adjusted.
Adjust the drag links so that equal lengths of each are threaded into
the ball joint on the left side and the ball joint on the right side:
1. Remove the hex nut below the ball joint. See Figure 24.
Axle
2. Thread the ball joint inward to shorten the drag link. Thread the
ball joint outward to lengthen the drag link.
3. Replace the hex nut after proper adjustment is achieved.
NOTE: Threading the ball joints too far onto the drag links will cause
the front tires to "toe-in" too far. Proper toe-in is between 1⁄16" and
5⁄16".
Front tire toe-in can be measured as follows:
1. Place the steering wheel in position for straight ahead travel.
2. In front of the axle, measure the distance horizontally from
the inside of the left rim to the inside of the right rim. Note the
distance.
3. Behind the axle, measure the distance horizontally from the inside
of the left rim to the inside of the right rim. Note the distance.
4. The measurement taken in front of the axle should be between
1⁄16" and 5⁄16" less than the measurement taken behind the axle.
Hydrostatic Transmission
The hydrostatic transmission is sealed at the factory and is mainte-
nance-free. The fluid level cannot be checked and the fluid cannot be
changed.
26
Ball Joint
Drag Link
Hex Nut
Figure 24