Advertisement
Quick Links
π
H-8783
UNIVERSAL LABEL REWINDER
TOOL NEEDED
Phillips Screwdriver
3
4
1 2
12
NOTE: Assembly of the unit requires a Phillips
screwdriver.
1. Align holes in base with holes in bottom of tower.
2. Use four Phillips screws to attach base to tower.
(See Figure 1)
1.
Remove plastic overlay from Lexan disks.
2. Slide a Lexan disk onto the shaft.
NOTE: Ensure the disk rests on the small ridge
on the shaft.
PAGE 1 OF 3
3
6
5
4
10
11
1-800-295-5510
uline.com
PARTS
PARTS
7
8
9
ASSEMBLY
Figure 1
Philips
Screw
SETUP
3. Select a 3" core holder with the small metal blades
on the edge.
4. Slide and thread the 3" core holder onto shaft with
beveled edge facing away from tower.
#
DESCRIPTION
1
Mounting Flange
2
Thumbscrew
3
Lexan Disk
4
3" Core Holder
5
Empty Core
6
Shaft
7
Tower
8
Base
9
Phillips Screw
10
Roller
11
AC Adapter
12
Power Cord
QTY.
1
1
2
2
1
1
1
1
4
1
1
1
Tower
Base
0220 IH-8783
Advertisement
Related Manuals for U-Line H-8783
Summary of Contents for U-Line H-8783
- Page 1 π H-8783 1-800-295-5510 uline.com UNIVERSAL LABEL REWINDER TOOL NEEDED Phillips Screwdriver PARTS PARTS DESCRIPTION QTY. Mounting Flange Thumbscrew Lexan Disk 3" Core Holder Empty Core Shaft Tower Base Phillips Screw Roller AC Adapter Power Cord ASSEMBLY NOTE: Assembly of the unit requires a Phillips...
- Page 2 SETUP CONTINUED CONNECTING POWER CABLE AND AC CORD 5. Slide an empty cardboard core onto shaft. Ensure it fits snugly onto 3" core holder and flush against Lexan disk. (See parts diagram on page 1) Plug power supply into inlet on tower. NOTE: The empty core should be 2.
- Page 3 TROUBLESHOOTING OPERATING ISSUE RECOMMENDATIONS Rewinder feeds supply, Ensure the direction switch is set properly. instead of rewinding. Core does not stay on Ensure the inside core holder is the one with the small core holder. metal clips on the edge. Supply is pinched when Ensure the outer disk has not been pushed in too far.