U-Line DYMO 450 Quick Start Manual

π
H-1240
DYMO LABELWRITER 450
®
PRINTER FEATURES
Your LabelWriter printer is a direct thermal printer and
does not use toner, ink cartridges or a ribbon. Instead, it
uses heat from a thermal print head to print on specially
treated labels. Labels are the only supply you will ever
have to buy.
Figure 1 depicts the major components of the printer.
Figure 1
USB
Connector
Cable
Channel
TO INSTALL SOFTWARE ON A WINDOWS SYSTEM
NOTE: Do not connect the printer to a
computer until instructed to do so during the
software installation.
1. Insert the LabelWriter CD into your CD-ROM drive.
After a few seconds, the installation screen appears.
If the installation screen does not appear:
a. Click Start then Run on the Windows taskbar. The
Run dialog box appears.
b. Enter D:\Install.exe (where D is the letter assigned
to the CD-ROM drive) and click OK.
2. Select the language version you wish to install and
follow the instructions.
PAGE 1 OF 3
1-800-295-5510
uline.com
FEATURES
DC Power
Connnector
Platen Release
Label Feed Path
and Tear Bar
Form-feed Button
and Status Light
SOFTWARE INSTALLATION
The form-feed button on the front of the printer
advances a single label. The label eject button is used
to remove labels from the printer when changing rolls.
The LED status light allows you to visually determine the
current state of the printer:
• Solid blue - power is on and the printer is ready.
• Flashing blue - labels are not loaded properly or
label spool is empty.
Top Cover
Label Roll
TO INSTALL SOFTWARE ON A MAC OS SYSTEM
1. Insert the LabelWriter CD into the CD-ROM drive.
After a few seconds, the DYMO Label Software
Installer icon appears.
2. Double-click the Installer icon
and follow the instructions.
3. When the Printer Setup Utility opens, add this printer
as follows:
a. Click Add.
b. Select the LabelWriter 450 printer from the list.
c. Click Add.
Label Spool
Label Eject Button
0715 IH-1240