U-Line MONARCH 1110 Instructions Manual

π
H-707
MONARCH 1110
ONE LINE LABEL GUN
CHANGE THE INK ROLLER
Figure 1
Figure 2
Figure 3
SET PRINT CHARACTERS
Figure 4
3. Repeat steps 1-2 for each band.
4. Push in the knob when you are done.
PAGE 1 OF 6
1-800-295-5510
uline.com
INSTRUCTIONS
1. Turn latch to release
ink roller door and
carefully pull ink roller
completely out of
labeler. (See Figure 1)
2. Insert folded backing
paper between ink
roller and carrier. Pull
to snap old ink roller
free. (See Figure 2)
3. Cut off end of ink
roller package. Using
package to protect
fingers, slide carrier
into package and
snap new ink roller into
place. (See Figure 3)
4. Slide ink roller door
back into place and
turn latch to lock.
1. Pull knob until indicators
are on the desired
band. (See Figure 4)
2. Turn the knob until
the desired character
appears black on a
white background
between the indicators.
(To print a blank, select
the blank space for
that band).
LOAD LABELS
1. For loading a new roll of labels, tear off and discard
the first 10 inches of label and liner. Tear backing
evenly between cuts.
2. Peel the first 12 labels from liner and discard.
HUB
Figure 5
BRAKE
WHEELS
LABEL EXIT
TRIGGER
Figure 6
LABEL EXIT
PLATE
LOOP
Figure 7
Figure 8
SLOT
BACKING
PAPER EXIT
NOTE: If backing paper does not become
taut and exit at rear, turn labeler upside down,
squeeze trigger and pull backing paper out of
slot. Repeat steps 5, 6 and 7.
Para Español, vea páginas 3-6.
3. Place the label roll
between the hubs and
click into place. (See
Figure 5)
4. Squeeze and hold the
trigger while feeding
the label strip into the
slot below the brake
wheels until about 6
inches come out of the
front. (See Figure 6)
5. Feed label strip under
the plate and pull
through until loop is
removed. (See Figure 7)
6. Squeeze and hold the
trigger while feeding
the label strip into the
slot below the arrow
until it stops/hits the
back. (See Figure 8)
7. Hold the strip in place
and squeeze the
trigger eight times or
until label strip feeds
through the rear exit.
(See Figure 8)
8. Remove any loose
labels.
0713 IH-707