Appendix A Installing 3Rd Party Software; Installing Citrix  Winframe  Software On The Commplete - Multitech CommPlete CC9600 User Manual

CC9600 Chassis User Guide

Appendix A Installing 3rd Party Software

This appendix describes how to install the following software packages on the CommPlete Communication
Server:
• Citrix  WinFrame 
• Microsoft  Windows  NT
• SCO  UNIX 
• Novell  UNIXWare 
• BSD  UNIX 
These procedures can be performed only by using the optional DA96002 load card.
SCO UNIX, UNIXWare, and BSD UNIX procedures to be added later.
Installing Citrix    WinFrame    Software on the CommPlete
This procedure tells how to install the Citrix  WinFrame  software package on the CommPlete
Communication Server. This procedure can be performed only by using the optional DA96002 load card.
1. Start the Citrix install procedures (refer to the applicable Citrix WinFrame documentation).
2. When the CommPlete system is back running, copy the I386 directory from the Citrix CD to the root
3. Copy the ISI608 driver disk to the root directory of the CommPlete's hard drive.
4. Install any software that you need which requires the CD-ROM drive or the floppy drive.
5. Remove the IDE CD-ROM from the system. At the main menu, select "Winframe setup". Under
6. At the Control panel, select "Devices". Highlight the atdisk device. Select the Startup button and
7. Exit the menus and shutdown the CommPlete system.
8. Remove the RASCard, MT3334HD8 modems, and remove the DA9600 card and cables.
9. Re-install the RASCard and MT3334HD8 modem cards.
10. Restart the CommPlete system.
11. Install the ISI608 drives. Under the Main menu, select "Control Panel" and then select
12. Select "Add new adapter".
13. At the bottom of the list select "Disk from manufacturer".
14. Enter the path for the ISI608 drivers (e.g., "c:\isi608\winnt\"). The system will start installing the
15. Select "Three" cards. A prompt will ask for the I/O address and IRQ of the first card.
10
directory of the CommPlete's hard drive.
"Options", select "Add/Remove SCSI devices". Highlight "IDE CD-ROM drive" and click on
"Remove".
click on "BOOT". This will put a circle in the boot section.
"Networking".
drivers. The message box "How many cards?" is displayed.
CommPlete Communications Server