Rds (Radio Data System) - Teac AG-680 Owner's Manual

Manual Memory Presetting
POWER ON
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the TUNING MODE button to change to
TUNING mode. (The Preset CH indicator disappears
from the display.)
4. Select the frequency you want to preset by pressing
TUNING/PRESET UP or DOWN button.
5. Press the MEMORY button briefly, MEMORY display
will blink at an interval of 1 second.
6. While the MEMORY indicator is lit, press the
TUNING/PRESET button to select the channel
number in which the data for the broadcast is to be
stored then press the MEMORY button again
Using the Memory Scan Function
When the MEMORY SCAN button on the remote control
unit is pressed, the preset channels in which
frequencies in the band (AM or FM) selected have been
stored are scanned at 5-second intervals. When you
hear a broadcast you want to listen to, release the
Memory Scan function by pressing the MEMORY SCAN
button again.
1 2 3 4,6 5

RDS (Radio Data System)

RDS is a broadcasting service which allows stations to
send additional information along with the regular
radio program signal. RDS services can be received
only in FM band.
RDS Display
POWER ON
1. Select the TUNER function.
2. Press the BAND button to select FM.
3. Select the RDS broadcasting by use of the TUNING
MODE button and the TUNING/PRESET buttons.
The RDS indicator lights in the display.
This unit receives and displays the following kinds of
data.
PS (Program Service Name): Displays FM station
name.
PTY (Program Type): Program type will be displayed
while receiving FM.
RT (Radio Text): Displays the news of stations
composed of up to 64 symbols.
CT (Clock Time): Displays the information about
times provided from the station.
TP (Traffic Program)
TA (Traffic Announcement)
4. Press the RDS MODE button.
Each time you press the button briefly (0.5 sec or
less), the modes will change as follows regardless of
the current mode.
T PS T CT T PTY T RT T TA T RDS off
(1) PS mode
When you select PS with the RDS MODE button,
"PS" will blink for about 4 seconds.
After 4 seconds, PS or a station name will be
displayed.
– 11 –
1 2 3 3 4