Audio Adjustments; Radio Reception; Auto Tuning - Teac AG-780 Owner's Manual

Audio Adjustments

POWER Button
Press this button to turn the power on.
Press it again to turn the system off.
STANDBY INDICATOR
The indicator lights up in power standby mode and goes
out when this unit is turned on.
SPEAKERS Select Buttons
These buttons are used to select speaker system A or B.
BASS/TREBLE Buttons
These two tone buttons (BASS and TREBLE) can be used
to obtain a "flat" frequency response or a tone which
suits your individual listening preference. The BASS but-
ton adjusts low frequencies and the TREBLE button
adjusts the high frequencies.
BALANCE Button
This button is used to adjust the balance between the
left and right channels. Normally set to the center posi-
tion.
LOUDNESS Button
This button compensates for the non-linear response of
the human ear at low volumes. Set this switch to the OFF
position when listening at normal levels.
MUTING Button (on the Remote Control Unit)
Press this to mute (–20 dB) the sound from the speakers
and headphones when answering the telephone, etc.
To restore the original volume, press the MUTING but-
ton again. While muting is engaged, the MUTE
indicator will flicker.

Radio Reception

Auto Tuning

1. Press the TUNER button*.
* The TUNER button can also be pressed instead
when you want to listen to a station selected last
by changing from another source.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the TUNING MODE button to change to
MANUAL mode. (The
from the display).
● This button is used to select Tuning or Preset mode.
4. Press the UP or DOWN TUNING/PRESET button
(within 0.5 to 2 seconds). The next station broadcast-
ing at a frequency higher or lower than that of the cur-
rent station is automatically detected and tuned in.
● By pressing and holding the TUNING/PRESET button
for longer than 2 seconds, it will continue to control.
● FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
Stereo
If FM stereo broadcast is received, the STEREO
indicator lights in the display.
Monophonic broadcasts are received in mono.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
– 12 –
CH indicator disappears