Fujitsu AU G45LRLA Series Design & Technical Manual page 36

8) Room temperature sensor switching
(Only for wired remote controller)
When using the Wired remote controller temperature sensor, change the setting to "Both" (01).
Setting Description
Indoor unit

Both
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
*Remote controller sensor must be turned on by using the remote controller.
9) Remote controller custom code
(Only for wireless remote controller)
The indoor unit custom code can be changed.
Select the appropriate custom code.
Setting Description
A

B
C
D
10) External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Setting description
Operation/Stop mode

(Setting prohibited)
Forced stop mode
11) Room temperature sensor switching (Aux.)
To use the temperature sensor on the wired remote controller only, change the setting to "Wired
remote controller" (01).
This function will only work if the function setting 42 is set at "Both" (01)
Setting Description
Both

Wired remote controller
12) Indoor unit fan control for energy saving for cooling
Enables or disables the power-saving function by controlling the indoor unit fan rotation when the
outdoor unit is stopped during cooling operation.
Setting description
Disable
Enable

00: When the outdoor unit is stopped, the indoor unit fan operates continuously following the
setting on the remote controller.
01: When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low
speed.
(  . . .Factory setting)
Function Number Setting Value
42
Function Number Setting Value
44
(  . . . Factory setting)
Function number Setting value
46
(  . . .Factory setting)
Function Number Setting Value
48
(  . . . Factory setting)
Function number Setting value
49
- (01 - 33) -
00
01
00
01
02
03
00
01
02
00
01
00
01