Fujitsu AU G45LRLA Series Design & Technical Manual page 34

CONTENTS OF FUNCTION SETTING
„ „
• Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
• The settings may be selected between the following two: Function Number or Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
1)
2)
3)
4) Vertical airflow direction range control
5) Room temperature control for cooling
6) Room temperature control for heating
7)
8) Room temperature sensor switching
9)
10)
11) Room temperature sensor switching (Aux.)
12) Indoor unit fan control for energy saving for cooling
1) Filter sign
Select appropriate intervals for displaying the filter sign on the indoor unit according to the
estimated amount of dust in the air of the room.
If the indication is not required, select "No indication" (03).
Setting Description
"Standard
(2,500 hours)"
"Long interval
(4,400 hours)"
"Short interval
(1,250 hours)"
No indication

2) Ceiling height
Select the appropriate ceiling height according to the place of installation.
Setting Description
Standard

3.2m
High ceiling
4.2m
Low ceiling
2.7m
In case of Cassette type models:
The ceiling height values are for the 4-way outlet.
Do not change this setting in the 3-way outlet mode.
Filter sign
Ceiling height
Outlet directions
Auto restart
Remote controller custom code
External input control
Function Number
11
Function Number
20
- (01 - 31) -
(  . . .Factory setting)
Setting Value
00
01
02
03
(  . . .Factory setting)
Setting Value
00
01
02