Table of Contents
Advertisement
4.2.2.2 VoIP/Line Configure/ Line Setting
/VoIP Setup/Line Configure/Line Setting/
This page will setup the phone line information each port.
a.
Port: display the port number, e.g. 1 or 2.
b.
Interface: Telephone interface type:
FXO: for connect to telephone line or PBX extension line.
FXS: for connect to regulate phone set
a.
Name: Line name for this port. This will send and display on the remote
side during VoIP call
b.
Line number: Telephone number assigned to this line.
c.
TxGain: Transmitter Gain. This will adjust the speaker volume of local
phone set. The adjust range is from +3 to -13dB. Higher value will cause
louder sound come from local phone set.
d.
RxGain: Receiver Gain. This will adjust the microphone volume of local
phone set. The adjust range is from -3 to +13dB. Higher value will increase
amplifier the sound get from local phone set.
e.
Inbound: Enable or disable the VoIP call to Internet. Disable the inbound
option will not allow any call made from phone set to Internet.
f.
Outbound: Enable or disable the VoIP call from Internet. Disable the
Outbound option will not allow any call made from Internet to phone set.
g.
Hotline: When Enable, it will allow you to make a VoIP call without Press
any number. That mean it will direct call out by VoIP when you off hook the
phone of this line.
For example, if you want line 1 to become a hot line for VoIP call, every time
19
Advertisement
Table of Contents
