Siemens SIMOTICS S-1FK2 Service Manual page 48

Description
2.4 Encoder replacement variants
9 Install the new gap fillers.
10 • Remove the foil from the adhesive surfaces of the
gap fillers.
• Glue the small round gap filler
at the position shown.
• Glue the new large gap filler
ics board at the position shown.
11 Attach the motor cover so that the hole in the cover
lines up with the pin in the motor enclosure
Carefully ensure that the gap fillers are at the correct
position and remain in this position.
12 Tighten the cover crosswise using the 4 M5 fixing
screws with the maximum tightening torque 5 Nm.
❒
46
②
onto the encoder
①
onto the electron‐
①
②
.
Encoder replacement for SIMOTICS S-1FK2 and S-1FT2
Service Manual, 07/2022, A5E52211160B AA