Shark 3DCOMPLETE VM200 Quick Start Manual

Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
CORDLESS HARD FLOOR CLEANER WITH DISPOSABLE PADS
QUICK START GUIDE
WHAT'S INSIDE
A D
Handle 20 3DPICKUP Pads
B Pole E 3DPICKUP Multi-Surface Cleanser
C Main Body F Charger

ASSEMBLY

Insert the handle (A)
into the pole (B) until
you feel a click.
Then, insert the wand
into the neck of the
main body (C).
Push the handle and main
body together until you
feel them click into place.
D
E F
NOTE: For proper operation, ensure all parts
are firmly CLICKED into place.
VM200_QSG_EB1_STD_Mv5
3DCOMPLETE
A
(Click)
B
(Click)
C
CHARGING
Plug the charger into an electrical outlet, then insert
the charger plug into the port on the back of the
main body. The unit will begin charging.
As the unit charges, the green indicator light
will pulse slowly. When charging is complete, the
indicator light will illuminate solid green. After 10
seconds of inactivity, the light will turn off on its
own to conserve energy.
NOTE: The main unit comes with a partial charge.
For maximum runtime, charge fully before use
(approximately 2.5 hours). Leaving the unit plugged
in will not damage battery life.

FILLING THE RESERVOIR

Reservoir
Lid
Lift the reservoir lid and press it up until it clicks
into locked open position. Empty 12 oz bottle into
reservoir.
NOTE: When filling the reservoir, always hold the
main unit upright to prevent spills.
Never fill the reservoir when the unit is charging.
™
© 2019 SharkNinja Operating LLC.