Table of Contents
Advertisement
Installation Hints
Please consider the following points when mounting the sensor:
•
The sensor must be aimed so that it does not directly face the sun or any bright light to avoid causing damage to
the sensor.
•
The Motorola Wireless Motion Sensor is constructed of UV-resistant ABS plastic. Do not install the sensor where
it is subjected directly to the elements.
•
This device's communication range is up to 60 feet from the Wireless System Controller in a typical home,
depending on the number of obstacles. These can include metal framing, thick walls, and other wireless devices
operating at 418 MHz. It is recommended that different positions be tried for optimal results.
Installing Your Wireless Motion Sensor
Your sensor can either be mounted on a wall or just sit on a horizontal surface.
Wall Mount Your Wireless Motion Sensor
Warning: When mounting near a window, drilling too close to the glass could break the glass, possibly cause it to
shatter, and cause injury. The window extends deeper into the frame than can be seen; therefore, ensure your screw
is beyond the glass before drilling.
1
Using the holes on the drilling template found later in this guide, mark the position of the
to be drilled.
For drywall or other composite surfaces, use a 7/32" drill bit. Drill a hole for each of the
mounting screws and insert a plastic wall anchor into each hole.
For solid surfaces, use a 1/16" drill bit. Drill a pilot hole for each of the mounting screws.
2
Ensure that fresh batteries have been installed.
3
Position the sensor to survey the desi
sensor distance works up to 20 feet .
4
Using the screws provided, secure the mounting bracket to the wall. Be sure to mount the sensor in the manner
pictured above so that the unit has free motion for optimum aiming.
Tabletop Mount Your Wireless Motion S
The sensor can be placed on any horizontal sur
1
Locate the sensor on a horizontal surface.
2
Ensure that fresh batteries have been installed.
3
Screw on the tablemount base.
4
Make adjustments to the sensor coverage angle by tilting and panning the unit with your hand.
red area. Please keep in mind that the field of view is 90 degrees and motion
ensor
face.
4
holes
Advertisement
Table of Contents
