Table of Contents
Advertisement
3
Position the camera to view the desired area and plug in the power supply. Please keep in mind that the
field of view is 80 degrees and the motion sensor distance works up to 12–14 feet (3.5–4 m).
4
Make adjustments to the camera viewing angle by tilting and panning the camera head with your hand.
Table Mount Your Wireless Motion Sensor Camera
The camera can be placed on any horizontal surface.
1
Place the camera on a horizontal surface.
2
Plug the power supply into the camera and then to a wall outlet.
3
Make adjustments to the camera viewing angle by tilting and panning the camera head
with your hand.
Installing Your Door/Window
Installing your sensor is a simple process.
1
Locate the antenna and screw it into the top-right corner of the sensor, jus
secure.
Sharp objects should be stored out of reach of children to prevent injury.
2
Insert the batteries. On the bottom of the sensor, slide open the door
alkaline batteries. The back of the battery door of the sensor indicates
the polarity (+ and -) of the batteries. Close the door after inserting
batteries.
The sensor does not support rechar
However, the sensor does employ built-in power saving functionality.
3
Register your sensor with your Wireless System Controller us
Mount Your Door/Window Sensor
Discover your sensor before mounting it.
The spacing between the sensor and the contact should be between 1/10 inch and ½ inch (.25 cm to 1.27 cm).
1
Using the supplied double-sided tape, peel one side of the paper strip and p
sensor. Peel the other side of the tape and place the sensor in the location desired. (See the diagram
sample mounting.)
2
You can also mount the sensor more securely using the screws in the
hardware kit. Using the drilling template found later in this guide, drill two
pilot holes for the screws. Affix the screws to one side of the object (typicall
the side to be attached to the door/window frame), leaving 1/16" (1.6 mm)
Discovery
button
Sensor
geable NiCad or NiMH batteries.
5
Detach base
t above the air vents, u
and
insert two AAA
ing a process called Discovery.
lace
it on the back of the
y
ntil it is
for
1.6 mm (1/16 inch )
maximum
Advertisement
Table of Contents
