Transmitter Button Functions; Replacing Remote Control Batteries - Code Alarm Professional Series CA 4050 Owner's Manual

Valet Mode
Valet Mode is used to disable the system from remote starting. To
enter or exit valet mode simply follow the 4 steps outlined below:
1. Turn the vehicle's ignition ON.
2. Push and hold the programming/valet button.
3. The LED will turn on solid when valet mode is active
4. Release the programming/valet button.

Transmitter Button Functions

1 Button Transmitter
Unlock
Remote Start
Remote Start Shut Down

Replacing Remote Control Batteries

1-Way Remote Control:
The batteries (model CR2016) inside each remote control should last approximately
1 year under normal use. When the batteries become weak you will notice the
remote control range (the distance from the vehicle the remote control will work)
deteriorate and the small LED on the remote control will dim. To replace the remote
control batteries:
1. Unsnap and disassemble the halves of the remote control.
2. Remove the old batteries, observing the +/- symbols on the batteries and
replace with new CR2016 batteries.
3. Reassemble the halves of the remote control.
4. Test operation of the remote control.
4
Start / Aux Operation Method
Press and Hold - During
X
remote start only
Press and Release (1 or 2
X times depending on
selectable option)
Press and Release (1 or 2
times depending on
X
selectable option)
2009 Audiovox Electronics Corporation. All rights reserved.