Installing The Fixture - Woods L6008 Installation Manual

INSTALLING THE FIXTURE

Do not remove ANY preinstalled CRIMP CONNECTORS ONLY LOOSE WIRES NEED TO BE CONNECTED
and local electrical codes.
2. Use only 120 Volt, 60 Hz power supply
additional base in the proper size.
4. To begin installation, take waterproof silicone and place at small bead around the diameter
5. Install the 4" metal strap to your junction box with two screws.
6. Next, slide the black foam gasket over the white, black and the bare copper grounding wires.
The gasket and silicone provide a double layer of protection against water and future problems.
See diagram
White to White Black to Black
B
A
Cross Bar
C
Green to Green
7. Ensure all wire nuts are snug and properly installed
back plate being careful not to pinch any wires. In the event your junction box is deep in
the wall obtain a longer screw from a hardware store. Make sure you match the threads correctly.
10. Adjust the Motion Sensor to the desired angle and lightly tighten into place. During SET-UP
this most likely will need adjusted again
11. Turn the power back ON by switching the circuit breaker and wall switch to the ON position
LEDs will be chasing back and forth
WARNING: Maintain a minimum of 1.5" (3.8cm) distance between the light bulbs
Do not let bulbs touch ceiling. Keep a minimum of 2" distance from ceiling.
Mounting Bolt
Rubber Cap
Gasket
4
A:
to the white wire from the house
B:
to the black wire from the house
C: Connect the green wire from the
the house