Unpacking The Unit - Zanotti UNO Series Installation Manual

3.4 Unpacking the unit

To unpack the unit proceed as follows:

Carefully remove the upper and side structures of the packaging crate, then remove the lower
panel and the installation kit components supplied with the unit.

Remove the coatings and accessories of the unit present

Attach the unit, using the holes in the supports (A, Figure 22), to a suitable lifting device and lift it
slightly.

Remove the screws that fix the unit to the packaging crate.

Remove the two rear stations of the packaging crate and lift the unit from the base at a height of
about 300 mm [11.81 in].

Remove the four mounting bolts that fix the two vertical columns to the unit.
The unit is ready to be installed.
24
INSTALLATION MANUAL
Figure 22 - Anchor brackets
Refrigeration unit
Series Uno Undermount
UN120 | UN120 Multi
rev.02