3.6 Evaporator installation
DANGER
Evaporators contain nitrogen under pressure. Before installation, release the nitrogen as
described in this paragraph.
To install the evaporator proceed as follows:
Slowly unscrew the caps on the defrost lines (1,Figure 27), liquid (2) and suction (3) to allow the
nitrogen to gradually escape.
Remove the evaporator panel to access the fastening holes.
Place the evaporator in accordance with the distances indicated in the following paragraph 3.6.1.
Install the evaporator using the holes indicated in the paragraph 2.1.2.
28
INSTALLATION MANUAL
Figure 27 - Protective caps
Refrigeration unit
Series Uno Undermount
UN120 | UN120 Multi
rev.02