WORKMASTER GO-M04 Operator's Manual page 14

IMPORTANT
CAUTION
7. When the gate is fully closed, stop ratcheting and remove the GO-M04 from
the car's capstan socket.
The preferred method is to pull on a ratchet wrench.
Pushing on the ratchet wrench is normally considered
dangerous because if slippage or breakage occurs, the
operator can strike his/her knuckles. Sometimes,
however, this is the only way the tool can be used. If
this is the case, use extra caution, eg, wear gloves,
use a shorter stroke, etc.
If the railcar gate will not move, STOP using the
GO-M04 Opener, and notify your supervisor,
continued operation will damage the Opener.
Do not use other opening devices (pry bars,
multipliers, etc.) in an attempt to "help" the
GO-M04 Opener.
PH: 866.476.9217 10