WORKMASTER GO-M04 Operator's Manual page 11

IMPORTANT
CAUTION
7. When the gate is fully open, stop ratcheting and remove the GO-M04 from
the car's capstan socket.
Maintain firm hand control of the GO-M04 or the
ratchet wrench handle during entire opening
operation.
The preferred method is to pull on a ratchet wrench.
Pushing on the ratchet wrench is normally considered
dangerous because if slippage or breakage occurs, the
operator can strike his/her knuckles. Sometimes,
however, this is the only way the tool can be used. If
this is the case, use extra caution, eg, wear gloves,
use a shorter stroke, etc.
If the railcar gate will not move, STOP using the
GO-M04 Opener, and notify your Supervisor.
Continued application of force will damage the
Opener.
Do not use other opening devices (pry bars,
multipliers, etc.) in an attempt to "help" the
GO-M04 Opener.
PH: 866.476.9217 7