Using Your Refrigerator; Setting The Controls - Kenmore 795.7902 Series Use & Care Manual

SETTING THE CONTROLS

TEMPERATURE
• The Refrigerator Temp. Control ranges from 33°F to
43°F (1°C to 7°C). Press the Refrigerator temp button
to cycle through the available temperature settings one
increment at a time.
• The Freezer Temp. Control range is from -7°F to 5°F
(-23°C to -15°C). Press the Freezer Temp button to
cycle through the available temperature settings one
increment at a time.
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are set
correctly when milk or juice is as cold as you would like
and when ice cream is firm. If the temperature in either
compartment is too cold or too warm, change the setting
one increment at a time. Wait 24 hours for the change to
stabilize before adjusting again.
Temperature Mode Switch Function (°F <->°C)
If you want to convert °F to °C or vice versa, press and
hold the Freezer and Refrigerator buttons at the same
time for approximately 5 seconds.
AIRFLOW
Cold air circulates from the freezer to the fresh food
section and back again through air vents in the wall
dividing the two sections. Be sure not to block vents while
storing items in your refrigerator. Doing so will restrict
airflow and may cause the refrigerator temperature to
become too warm or cause interior moisture buildup. (See
airflow diagram below.)
ACCELA ICE
This function increases both ice making and freezing
capabilities.
• Press the Accela Ice button to illuminate the LED
and activate the function for 24 hours. The function
automatically shuts off after 24 hours.

USING YOUR REFRIGERATOR

•
•
•
DISPLAY MODE (FOR STORE USE ONLY)
•
•
NOTE: When the refrigerator is in the Power Saving
Mode, the display remains off until a door is opened
or a button is pressed. Once on, the display remains
on for 20 seconds.
19
Stop the function manually by pressing the button
again.
display and the function is activated.
To disable the function, press and hold the Lock button
for approximately 3 seconds.
CAUTION
The Display Mode disables all cooling in the
refrigerator and freezer sections to conserve energy
while on display in a retail store. When activated, OFF
will display on the control pad..
To deactivate / activate:
With either refrigerator door opened, press and hold
the Refrigerator Temp and Accela Ice buttons at the
same time for five seconds. The control pad will beep
and the temperature settings will display to confirm
that Display Mode is deactivated. Use the same
procedure to activate the Display Mode.
Accela
Ice