Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for iOptron Pier
Summary of Contents for iOptron Pier
- Page 1 ® ® iOptron Pier Instruction Manual Product #8030, #8033...
- Page 2 Pier Setup: iOptron pier comes in a single box. For #8030 (48” pier), all the parts are stored inside the pier tube, as shown in Fig.1. For #8033 (42” pier), three (3) poll rods may slide into the pier tube, but not as secure Figure 4 as #8030.
- Page 3 Adjust the length of the three Pull Rods. Hook one end of a Pull Rod onto a bolt located on the Pier To install an iEQ45 mount onto the pier, just simply Leg and the other Pull Rod end onto the mounting face the alignment peg north (if you are located in beam inside the Pier Tube.
- Page 4 Center Bolt For MiniTower Locking Screw Leveling Screws Figure 9 Pier with Alignment Peg and Center Stud Figure 11 Pier with MiniTower Center Bolt for iEQ30 Install 3 MiniTower level adjustment screws and threaded in about half of the threads. Put the MiniTower on to it.
Need help?
Do you have a question about the Pier and is the answer not in the manual?
Questions and answers