Advertisement
English
6. Operation
In the display, the data the detector is reading out is shown. As a rule
no leading zeros are displayed. In case the display shows a number
beginning with zero, an address between 10000 and 10239 is read out.
Display
----
---- / flashes
3
0003
C88
c14
7. Check list for troubleshooting
§
Parts are getting too hot and/or start to smoke.
!
Switch off the digital system immediately !
Possible cause: The display device is damaged. à Perform a visual
check and send in the PCB for repair if necessary.
§
The display does not show data.
Possible cause: The display device and the detector have not been
programmed to the same address. à Program the adresses of the
two devices anew. Make sure that only the detector to be
Page 18
Meaning
No detector connected / assigned or no vehicle
decoder in the supervised rail section.
No RailCom cutout identified. The RailCom cutout is
supplied by the booster and is indispensible for
feeding back data with RailCom. That is the reason
why the booster supplying the respective rail section
has to be RailCom-compatible.
Decoder address 3
Decoder address 10003
Consist address 88
Value of a CV read out: 14. While receiving data the
"c" flashes twice. The value read out is displayed for
approx. 5 seconds, then the decoder address is
displayed again.
RCA-1
Advertisement
