Advertisement
RCA-1
§
Shunt the two pins of the programming connection JP1 of the RCA-
1 and put the accesory detector into the programming mode.
§
Restore the connections to the power supply, firstly to the detector
and afterwards to RCA-1. Be sure that only the detector to be
assigned a new address is connected to the RCA-1 / the power
supply.
§
Immediately after having been connected to the power supply the
RCA-1 tranfers it´s address to the detector and by doing this
programs the detector to the same address. During the
programming process "SE" is shown in the display.
§
Disconnect the detector and the RCA-1 from the power supply.
Remove the shunting from the programming connection´s pins JP1
of the RCA-1. Put the detector back into standard operation.
English
Page 17
Advertisement
