Advertisement
RCA-1
1. Getting started
Checking contents
Please make sure that your package contains:
§
one or five modules (depending on the packaging unit),
§
one or five jumpers for programming the address,
§
this manual.
Required materials
In order to connect the display device RCA-1 you need wire.
Recommended diameters:
§
> 0,1 mm² for databus line,
§
> 0,25 mm² for all other connections.
Saftey instructions
The display device RCA-1 can be used in digital model railways in
concordance with these instructions to display RailCom messages, read
out by a local RailCom detector. It is not suitable for use by children
under 14. Incorrect use can be dangerous. In particular there is a risk
of electric shock through contact with metal parts under power,
especially when an incorrect voltage is used, or when operated in a too
humid or wet environment. Therefore the following precations should
be observed:
§
Wiring should only be carry out when the control is disconnected.
§
Only operate indoors in a dry environment.
§
Only use proprietry transformers with the correct voltage.
§
Only connect the transformer in an authorised manner to the house
power supply.
§
Use adequetly thick cable for all wiring. Too thin a cable can
overheat.
§
If the layout is exposed to condensation, allow at least two hours
for drying out.
English
Page 13
Advertisement
