Table of Contents
Advertisement
B-3
7. Operation
Operation display
The LED shows that the booster is in operation.
Shunting the boundry between two booster sections
One should arrange track sections so that it is not necessary to halt a
train directly on the boundry between two sections. This would lead to
a connection between the outputs and damaging of the two connected
boosters. The short circuit indication does not work under these
circumstances, therefore the central unit will not switch off the booster
automatically.
Loading the boosters
The average current supplied by the booster should not exceed 2,5 A,
as the booster otherwise indicates a short circuit to the central unit.
Short-term excention normally does not lead to a short circuit indication
and switching off the booster by the central unit.
8. Check list for troubleshooting
§
The booster is getting too hot and/or starts to smoke.
!
Disconnect the system from the mains immediately!
Possible reason: The connections to the track and the power supply
have been mixed up. à Alter the connections. Possibly the booster
has been damaged.
§
The LED on the booster does not light and it is not possible to
control locomotives.
Possible reason: The plug of the connecting cable to the central
unit has been put on the wrong way round. à Alter the connection.
Hotline
If problems with your booster occur, our hotline is pleased to help you.
(address on the cover page).
English
Page 21
Advertisement
Table of Contents
