Table of Contents
Advertisement
Cleaning the water cooler and hy-
draulic oil cooler, and checking them
for leaks
NOTE
Only clean the water cooler and hydraulic oil
cooler when the engine is switched off and has
cooled down.
Open the bonnet.
Release the 4 screws (2).
Remove the cover sheet (1) from the rear.
Cleaning with compressed air
Ventilate the cooler (3) of the engine with
compressed air.
Rinse out the released dirt using a water jet.
Cleaning with cleaner solvent
CAUTION
No humidity must penetrate the three-phase gene-
rator.
Therefore, protect it from direct contact with the
water jet.
Spray the cooler (3) with a conventional
cleaner solvent and leave it to work for ap-
prox 10 minutes.
Spray the cooler in the engine with a direct
jet of water until it is clean.
Operating Instructions – 393 807 1001 EN – 08/2008
Maintenance
1
2
2
3
5
Engine
d3921387
d3921399
127
Advertisement
Table of Contents
