Table of Contents
Advertisement
HORIZONTAL LOW-PROFILE FAN COILS
PRODUCT OVERVIEW
Safety Precautions
A. Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable codes and standards,
including fire-rated construction.
B. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
C. Use this unit only in the manner
intended by the manufacturer. If you
have any questions, contact the
manufacturer:
In the United States
2975 Shawnee Ridge Court
Suwanee, Georgia USA 30024
Ph: 770.623.8050
Fax: 770.623.6404
In Canada or International Export
Sales Office
638 Raleigh Street
Winnipeg, Manitoba
Canada R2K 3Z9
Ph: 204.669.4220
Fax: 204.663.2715
D. Before servicing or cleaning unit,
switch power off at service panel
and lock service panel to prevent
power from being switched on
accidentally.
E. Protect flammable materials nearby
when brazing, Use flame and heat
protection barriers where needed.
Always have a fire extinguisher
ready.
F.
The manufacturer assumes no
responsibility for personal injury or
property damage resulting from
improper handling, installation,
service or operation of the product.
Caution to Contractors
1.
Fan coil units are not intended for use as temporary heat or ventilation sources
during building construction. The fan coil units are not designed nor equipped
to operate in a dusty construction environment. Recirculating fan wheels can
become coated in construction dust, resulting in an unbalanced wheel, which
may contribute to reduced motor life. Inlet air filters, if supplied, provide little
protection as they would quickly become plugged with construction dust.
2.
Price recommends a minimum of three (3) duct diameters of straight inlet duct,
the same size as the inlet, between the unit inlet and any transition, take-offs or
fittings.
3.
Price recommends sufficient clearance for access panel removal. Local code and
the National Electrical Code clearance requirements take precedence and are the
responsibility of the installing contractor.
NOTE:
Price cannot warrant against any damage or poor performance due to
operating outside of the conditions outlined above.
Receiving Inspection
All Price fan coil units are inspected before shipment. After unpacking the assembly,
check it for damage. If any damage to the products is found, report it immediately to
the delivery carrier. Caution is required when unpacking the fan powered units with
electric coils as not to damage the elements.
Ensure that all packing material is removed from the inside of the unit,
especially around the blower wheel and coil section.
WARNING:
Do not adjust the control components.
priceindustries.com | HORIZONTAL LOW-PROFILE FAN COILS - Manual
1
Advertisement
Table of Contents
