Table of Contents
Advertisement
Correct Method of Use
4.1 How to use the cuff
(1) Place the cuff flat on the table, leave the hook & loop downwards,
and pass the end of cuff through the metal ring to form a loop. The hook
& loop shall point outwards.
(2) Pull the cuff through the upper arm to be measured, and wear the
cuff correctly based on the downward icon "Φ," the air tube runs down
the inside of your arm.
(3) Hook up the cuff on the upper arm according to the illustration,
ensure that the lower edge of cuff is 2~3cm away from the elbow joint.
(4) Tighten the free edge of cuff to stick the hook & loop.
(5) The cuff should be wrapped on the upper arm comfortably, with tight
space for two fingers. Before measurement, remove tight fitting clothing
from your upper arm along with any thick clothing.
(6) Place the lower arm flat on the desktop, leaving the center of palm
naturally upwards, sitting upright, and ensuring the center of cuff and
the heart are at the same level. Note that the tube of cuff cannot be
folded or bent.
Note: If you cannot use the left arm for measurement, please use the
right arm for measurement. All the measurements must be performed on
the same arm for comparison.
- 11
Advertisement
Table of Contents
