Advertisement
GATE INSTALLATION
R
30.5"
S
M
N
STEP 6
Measure vertically from floor and mark points as shown above
Pre-drill holes and insert WALL ANCHORS (S)
NOTE: Wall anchors are not needed if installing in solid wood
frame or studs
On side where gate will open, attach LOCKING LATCH (M) at
top and SADDLE (N) at bottom using MOUNTING SCREWS (R)
On side where gate will hinge, attach HINGES (O) at top and
bottom with MOUNTING SCREWS (R)
STEP 7
Insert ANGLE BOLTS into HINGES
Adjust length of STRAIGHT BOLTS to sit in LOCKING LATCH and SADDLE
NOTE: Make sure straight bolts and angle bolts are adjusted within the
minimum/maximum range shown below
+
+
28.4"
4.65"
3.6"
R
S
O
!
min 0.7"
max 2.4"
TOOLS REQUIRED
Drill
Hammer
Philips screwdriver
!
min 1"
max 2.9"
Advertisement
