Hitachi SH1 Series Basic Manual page 47

Chapter 4
4.1.4 Procedure for directly specifying or selecting a code
You can specify or select a code or data by entering each digit of the code or data instead of scrolling.The following shows an example of the
procedure for changing the monitor mode code to extended function code.
①
Display the monitor mode code.

2
Press the
*3)
FUNC
②
Change to the extended function mode.

Character"d"in the leftmost digit starts blinking.
Press the
1

Character"A"is blinking,Pressing the storage
key determines the blinking character.
●
Press the key
*2)
STR
FUNC
(to determine character "A").
③
Change the fourth digit of the code.


Character "A" is blinking.
Press once.
1

Character "b" in the fourth digit is blinking.
- Since thefourth digit need not be changed, press
the [STR] key to determine the character "0".
Character "9" in the first digit is blinking.
together.
④ Change the first digit of the code"AA101".
1
Character "1" in the first digit is blinking.
FUNC
*2)
twice.
Character "1" in the second digit is blinking.
Since the second digit need not be changed,
press the [STR] key to determine the character "1".
⑤ Change the second digit of the code"AA101".
*2) FUNC
⑥ Change the third digit of the code"AA101".
Press the
STR
(Character "b" is
determined.)
FUNC
*2)
"-" in the third digit is blinking.
- Since the third digit need not be changed,
press the [STR] key to determine.

Press the STR
(Character "9" is
determined.)
Press the eight times.
1

Press the
STR

Press the once .
1

Press the
STR

4-4
⑦
End the change of the extended function code.
.
Selection of code "Ab-19" is completed.
※ If a code that is not defined in the code list or not intended
for display is entered, the leftmost digit (fifrth digit) (character
"A" in this example) will start blinking again.
Press the key to display the data corresponding
FUNC
To thefunction code, change the data with the
or key, and then press the
2
changed data. (*4)
Note that you can also use the procedure (steps ① to ⑦)
described here to change the data. (*3)(*4)
*1
This procedure can also be used on screens displaying a
code other than "dA-01".
*2
If the key is pressed while a digit is blinking, the
FUNC
display will revert to the preceding status for entering the
digit to the right of the blinking digit.
*3
If the key is pressed while the leftmost (fifth) digit is
FUNC
blinking, the characters having been entered to change
the code will be cancelled and the display will revert to the
original code shown before the
pressed in step 1).
*4
When changing data, be sure to press the
Settings
and/
1
key to store the
STR
and keys were
1
2
key.
STR