Hitachi SH1 Series Basic Manual page 45

Chapter 4
4.1.2 Code display system
The initial display on the monitor screen after power-on depends on the setting of function"UA-91".When the setting of function"UA-91"=
"dA-01"(factory setting),the monitor initially show

The display to
,
Note: The display contents on the monitor depend on the setting of function "UA-10"(function code display restriction),"UA-91"
(initial-screen selection),and"UA-30"(automatic setting of user parameters).
Item
Function code display
restriction
Initial-screen selection
(Initial display at
power-on)
Selection of automatic
user-parameter settings
(*1) Not displayed with the factory setting。
※The following procedure enables you to turn the monitor display back to
Hold down the key for 4 seconds or more.The monitor shows
FUNC
During this status,press the
Note:The monitor shows
Running,the monitor shows an output frequency.
.
，

.
Function code Data
UA-10
dA-01
dA-02
UA-91
dA-03
(*1)
dA-06
FA-01
UA-30
(*1)
key.The monitor will show
FUNC
.
only when the motor driven by the inverter is stopped.While the motor is
as the setting of "dA-01" . Pressing the
Description
00 Full display
01 Function-specific display
02 user setting
03 Data comparison diaplay
04 Basic diaplay
Output frequency monitoring (factory setting)
Output current monitoring
Rotation direction monitoring
Scaled output frequency monitoring
Output frequency setting
00 Disable
01 Enable

or
.
.

.
4-2
key in this status changes
FUNC
(factory setting)
(factory setting)
.
Settings