Event Markings - Braemar ER910 Manual

ER910/920 and ER910/920 AF Event Monitor
Troubleshooting (page 2 of 2)
No information received by Make sure mouthpiece of phone is directly over Monitor
receiving center
speaker
Ensure RECORD/SEND button is held for two seconds.
Noise artifact on recorded
Mouthpiece of phone must be close to the Monitor speaker
ECG at receiving center hole.
Check telephone connection. Listen to phone line before
sending event(s) to ensure there is no noise.
Have patient call back and send ECG again.
Have patient try another phone.
Noise artifact on recorded Electrodes must be securely attached to patient.
ECG at patient location
Patient should remain still while recording.
Replace Patient Cable. Pulling on lead wires may damage
cable.
Verify the recording did not take place near a source of
electromagnetic interference (fluorescent lights, computer
monitors, or household appliances).
Move electrodes slightly to the right or left of the original
location.
All or groups of timestamps
If the inadvertent loss of power occurs, all the timestamps
for recordings are the in the FSK will reset to the time the unit powered back up.
same. Subsequent recordings will have time stamps relative to the
power up time.
Falling tone Transmission complete
Rising tone
Ready to record
17
ER910/920 and ER910/920 AF Event Monitor

Event Markings

The following shows typical event markings that are generated by the
Monitor and appear on the receiving station strip chart.
18