Dometic Go Power! GP-ADV-LiFePO4-100 Quick Start Manual page 2

INTERFACE DESCRIPTION
LED (POWER BUTTON) INDICATORS
LED Battery Mode Definition
Solid light Power on mode
Blinking light Sleep/Reserve mode
OFF Power off mode
VARIOUS POWER MODES
Press button for more than 3 seconds and release. The battery will enter sleep
mode. The LED will blink. Power off mode should only be used for long term
storage or to reset the BMS. Use sleep mode to disable output power of batteries.
Press and hold for 3s and release
Press and hold for 8s and release
Power off Power on
Press and hold for 3s and release
Press and hold for 3s and release
Power on
Sleep
Mode
Press and hold for 8s and release
Power off
Sleep Mode
®
BLUETOOTH APP
Scan the QR code to download the Go Power! Connect App
for use with the Sun Cycle Advanced Lithium Battery.
®
Press and hold for 3s and release
or charge battery to above 5Ah
Power on
Reserve
Capacity
Press and hold for 8s and release
Power off
Reserve
Capacity
CAN PORT WIRING
RV-C system
(if applicable)
Cable 3
HOW TO USE
To prevent a surge current, perform a "pre-discharge" as outlined
in the steps below.
Step 1 - Ensure all batteries are in Power Off mode.
Step 2 - Connect batteries following the series or parallel connection diagrams
found at gopowersolar.com/advanced-lithium-wiring. Cable 2 must
be installed for each battery pack followed by a Cable 3 cable on the
last battery.
Step 3 - Ensure battery pack terminals are correctly installed and connected to
the inverter system.
Step 4 - Press the power button on one of the battery packs for 3 seconds to
wake up all battery packs from Power Off mode. The LED indicator
will turn on.
Batteries are in Power Off mode when unboxed. Press the Power button
NOTE:
for 3 seconds to turn on. If it doesn't turn on, you will need to charge
the battery.
The batteries need to be configured before they can be used. Please see
battery manual for instructions on battery configuration.
Cable 1
Cable 2