Basic Configuration - Honeywell HZ322 TrueZONE Installation Manual

To enter Configuration:
Press the Mode button (the Config LED will
1
light up).
Use the Back and Next buttons to navi-
gate through the configuration settings.
2
Scroll through the selection choices by
using the "Adjust Setting" Left and Right
arrow buttons. Pressing Next enters the
selected option for that menu item and
advances to the next menu.
The flow chart below illustrates basic zone panel configuration. For additional configuration, see
3 Advanced Configuration on page 8. The label on the inside cover of the HZ322 Zone Panel also con-
tains configuration information.
Fig. 14
OPTIONS: 1, 2, 3
ASKS THIS FOR EVERY ZONE.
1
PANEL WILL NOT ASK IF YOU HAVE AUX HEAT WHEN 2 COMPRESSOR STAGES ARE SELECTED. THE HZ432 IS REQUIRED FOR A 3H/2C HEAT-PUMP.
2
SET TO "YES" IF WIRELESS (RADIO FREQUENCY) THERMOSTATS AND THM4000R ADAPTER ARE USED.
3
SHOWN IF COMPRESSR STAGES OR HEAT STAGES IS SET TO 2, OR AUX HT ENABLED IS SET TO "YES"
4 RF MEANS "WIRELESS THERMOSTAT"
SYSTEM TYPE
[CONV] HEATPUMP
CONVENTIONAL
COOL STAGES
0 [1] 2
HEAT STAGES
AUX HT ENABLED
0 [1] 2
RF ENABLED
[YES]
YES
ZONES INSTALLED
[3]
ZONE 1 TSTAT TYPE
[RF] WIRED
WIRED
4
RF
STAGE 2 CONTROL
3
[OFF]
ADVANCED CONFIG
[NO] YES
SAVE CHANGES
[NO] YES
WIRELESS HOME
CONFIG
CHECK OUT
MODE
BACK ADJUST SETTING NEXT
M24799
HEATPUMP
COMPRESSOR STAGES
[1] 2
1 2
1
[YES] NO
2
NO
NO
ZONES INSTALLED
[3]
ZONE 1 TSTAT TYPE
[HTPUMP-O]
OPTIONS: TSTAT,
TIMER, % ZONES, OFF
"YES" ALLOWS YOU TO VIEW/CHANGE THE ADVANCED
CONFIGURATION OPTIONS SHOWN ON PAGE 8.
7
HZ322 TrueZONE
CONFIGURATION
WIRELESS HOME
CONFIG
CHECK OUT
BACK ADJUST SETTING
Fig. 13
OPTIONS: 1, 2, 3
ASKS THIS FOR EVERY WIRED ZONE.
OPTIONS: HTPUMP-O FOR HEAT PUMP
THERMOSTATS USING O FOR CHANGEOVER,
HTPUMP-B FOR HEAT PUMP THERMOSTATS
USING B FOR CHANGEOVER, AND
CONVENTIONAL FOR CONVENTIONAL,
NON-HEAT PUMP THERMOSTATS
69-2199—05
MODE
NEXT
M24810
M28027A