Important Instructions For Use; Function Description - therm-ic S-PACK Instructions Manual

• Protection against overcharging and exhaustive
discharge: The S-Pack battery is protected against
overcharging and exhaustive discharge by the
integral electronic circuit during use.
HOW TO USE THE POWERSOCK BATTERY
• Wear the heatable sock.
• Push the S-Pack battery on to the snap fasteners
until they audibly lock into place (3.2).
• The S-Pack battery can be controlled with button
(1.3) or with a iOS and Android app (only for S-Pack
Bluetooth® enabled).

IMPORTANT INSTRUCTIONS FOR USE

• Do not allow the highest heat level to be switched
on for more than a few minutes at a time. This could
produce too much heat during operation, which
may cause burns.
• Always set S-Pack battery to low or moderate heat
levels to maintain comfortable foot warming (heating
should be almost undetectable).
• The optimum heat output is only reached when the
socks, boots or soles are dry.
• Never used the heatable sock and the heatable
insole together; this can result in too much heat -
risk of burning!

FUNCTION DESCRIPTION

S-Pack without bluetooth®
The S-Pack battery has 4 operating modes: POWER
OFF – IN USE LEVELS 1-2-3. They are indicated with
the heating level display on the S-Pack battery. The
LED flashing modes corresponds to the selected heat
setting.
S-Pack with bluetooth®
Using the phone App: Please refer to the Bluetooth®
app or www.therm-ic.com.
Turning the device on:
Press the control button (1.3) for a long period of time
(approx. 3 sec) to turn on the S-Pack battery at the
lowest heat level. If the control button is pressed for too
long (approx. more than 6s), the S-Pack will remain in
OFF mode.
11