Table of Contents
Advertisement
Quick Links
WALL MOUNTED HEATER
PLEASE READ ALL INSTRUCTIONS BEFORE USING
Model
PTC-21
IMPORTANT SAFEGUARDS
Thank you for buying our product. Please read this instruction carefully
before operating the heater. Keep this operating instruction for future
reference.
1. The heater should be hung on the wall and make the wind outlet
down or be placed on flat appliance. You must not place it
precipitantly or tipsily.
2. Please do not use the heater in the place where full of combustible or
explosive gas. Don't cover the wind outlet.
3. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
MODEL NO: PTC-21
Control
Remote control
Voltage
220-240V~
Frequency
Power
50/60Hz
2000W
Advertisement
Table of Contents
Related Manuals for Siku PTC-21
Summary of Contents for Siku PTC-21
- Page 1 WALL MOUNTED HEATER OPERATING INSTRUCTIONS MODEL NO: PTC-21 PLEASE READ ALL INSTRUCTIONS BEFORE USING Model Control Voltage Frequency Power PTC-21 Remote control 220-240V~ 50/60Hz 2000W IMPORTANT SAFEGUARDS Thank you for buying our product. Please read this instruction carefully before operating the heater. Keep this operating instruction for future reference.
- Page 2 order to avoid a hazard. The heater must not be located immediately below an electrical socket. The electrical socket must be equipped with earth wire, its capacity should be 250V~10A or exceed 250V~10A. The socket and the power plug should be in good connecting condition. 5.
- Page 3 on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- Page 4 on control panel to set power and time. 1. Turn on the heater by press the “ ” button on control panel, will be the natural wind out from the heater. ” button , will set the heater into low heat 2.
- Page 5 swinging blade 4. Press the “ ” button to set the timer as follows: 1H, 2H, 3H..12H. After finished timer setting, LED will display room temperature 5.When turn off the heater, press “ ” button once again. Fan keeps working for 30 seconds to blow the natural wind and cool down the heater inside .
- Page 6 OPERATION STEPS “On/off” Press the button the power is on, the appliance blows out natural wind. Press again, the power is off. “ ”selection of 1000W/2000W You can select powers 1000W/2000W through this button,Press one time,it is 1000w,Press two times,it is 2000W.
- Page 7 “Timer” Press the button to set the timer as follows: 1H, 2H, 3H..12H; it can be showed by the indicator lamp. Press the button to set the temperature up Press the button to set the temperature down. OVERHEAT PROTECTION The heater is protected with an overheat protector that switches off the heater automatically in case of overheat.
- Page 8 This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
Need help?
Do you have a question about the PTC-21 and is the answer not in the manual?
Questions and answers