Adjusting The "Ready In" Time Before The Programme Starts; Soaking Laundry; Adding Laundry; Cancelling The Programme - Bosch WAN282H2 User Manual And Installation Instructions

en Basic operation
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: "End" .
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
Press Start / Nachlegen / Pause.
1.
Press Fertig in repeatedly until
2.
the display indicates the desired
"Ready in" time.
Press Start / Nachlegen / Pause.
3.

Soaking laundry

You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start /
Nachlegen / Pause.
To resume the programme, after
3.
the desired soaking time, press
Start / Nachlegen / Pause.

Adding laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Start / Nachlegen / Pause.
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
Add or remove laundry.
2.
36
Close the door.
3.
Press Start / Nachlegen / Pause.
4.

Cancelling the programme

Once the programme has started,
you can cancel it at any time.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Start / Nachlegen / Pause.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Spülen programme.
– If the water level is high: Start
the Schleudern or Abpumpen
programme.
Remove the laundry.
3.
Resuming the programme
when the programme status
is Rinse Hold
Set the Schleudern or
1.
Abpumpen programme.
Press Start / Nachlegen / Pause.
2.

Unloading the laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Open the door.
1.