Water Inlet Fault; Water Drainage Fault - Miele G4203SCU Operating Instructions Manual

Water inlet fault

Problem
The / indicator
light flashes on and off.
The dishwasher stops
during a programme.
The / indicator
light flashes.
Fault code  or 
appears in the display.

Water drainage fault

Problem
The dishwasher stops
during a programme.
The / indicator
light flashes.
Fault code  appears
in the display.
Possible cause and remedy
The tap is turned off.
 Turn on the tap fully.
Before rectifying the problem, you must:
 Switch the dishwasher off with the  button.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the water inlet filter (see "Maintenance").
 The water pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
Possible cause and remedy
Before rectifying the problem, you must:
 Switch the dishwasher off with the  button.
The water outlet is restricted.
There might be water in the wash cabinet.
 Clean the filter combination (see "Cleaning and
care - Cleaning the filters").
 Clean the drain pump (see "Maintenance").
 Clean the non-return valve (see "Maintenance").
 Remove any kink or loop in the drain hose.
Problem solving guide
75