Special Cleaning Functions; Vapor Clean (On Some Models Only) - Smeg Classica SO4302S3X Manual

2. Carefully pull the frame towards the inside of
the oven cavity to unhook it from front
housing A.
3. Remove the frame from the rear pin B
located at the bottom of the side wall.
4. Repeat the operation for the frame placed
on the other side wall.
To refit the rack/tray support frames:
1. Slide the rear part of the frame into the
housing under the pin B located at the
bottom of the side wall.
2. Replace the front part of the frame in
housing A on the side wall near the opening
of the oven cavity.
91477A653/B
3. Screw in the front fixing pin (you can help
yourself with a tool, e.g. a coin).
4. Repeat the operation for the frame placed
on the other side wall.

Special cleaning functions

• From position 0, turn the function knob to the
left by one position. The

Vapor Clean (on some models only)

See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure which facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
Preliminary operations
Before starting the Vapor Clean:
• Remove all accessories from inside the oven
cavity.
• Remove the temperature probe (where
fitted).
• Remove the self-cleaning panels (where
fitted).
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
CLEANING AND MAINTENANCE - 83
button flashes.