Table of Contents
Advertisement
Problem
There is too much
frost.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
2
6.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regulator
is not set correctly.
1
1
Solution
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
1.
At the same time, with the fingers ex-
pand up and down the transparent cov-
er and unhook it in the direction of the
arrows.
2.
Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maximum
power is shown on the light bulb cover).
3.
Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the light
comes on.
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Cli-
Ambient temperature
mate
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
7.2 Electrical connection
Your appliance must be connected to a
single-phase supply of 230 V. Check that
the electricity meter is suitable for the
power consumed by your appliance, al-
lowing for the other connected applian-
ENGLISH
13
Advertisement
Table of Contents
