3.
For further assistance, go online for helpful instructional videos at bakcou.com
HANDLEBAR ASSEMBLY
8. Using 4mm Allen wrench, remove 4 screws from bicycle stem
9. After removing the front plate of bicycle stem, insert center of
handle bars into bicycle stem, then reattach the front plate and
4 screws to secure handlebars. (Make certain handlebars are
positioned with the throttle to the left and the rapid-fire index
shifting levers on the right. Slightly insert each of the 4 screws
prior to tightening. Also prior to tightening, rotate handlebars
forward or backwards to customize position of handlebars
to rider). Note: Most often, brake levers should be angled
approximately 45 degrees downward for optimal positioning.
10. Display screen can easily be rotated by hand, moving forward
or backwards, to accommodate rider's desired position.
FRONT FENDER & HEADLIGHT ASSEMBLY
11. Attach front fender and headlight to front fork bracket using
a long bolt from hardware package, 5mm Allen wrench, and
10mm wrench. Attach the light cable to the loose cable in the
cable harness. (Note: Place light bracket and fender bracket on
the backside of the fork bracket)
BAKCOU.COM