Servicing & Maintenance; Guarantee Regulations - Profi-pumpe INVERTER PUMP CONTROL 5 Operating Instructions Manual

THE MANUFACTURER EXPLAINS:
l To take over no responsibility in the case of accidents or damages on the basis of
carelessness or disregard to the instructions in this book.
l To reject every responsibility for the damages which originate from the improper use of
the device.
7. SERVICING
It may happen occasionally that dirt is retained in the internal check valve and this is no longer
seals 100%. The first remedy should be always trying to flush the check valve free. This is
done, for example, by turning on the garden-side faucet fully so that the pump delivers water
at full capacity for about 30 minutes. If the clocking does not disappear afterwards, the ad-
apter must be replaced. Before installing the new device, the pump must always be flushed
free as described above. Opening the device for purposes other than connecting the cables
is not permitted and always leads to the loss of any warranty claims. In addition, considerable
dangers can arise during operation of a cycling pump, so that the pump must not be operated
further under any circumstances. The pump must be taken out of service until the equipment is
replaced. Abrasive materials, such as sand, will shorten the maintenance time and equipment
life.
The following checks should be carried out regularly:
l functional test (min. every 3 months)
l integrity of the power cord
l Clean the guide lines (e.g. no buckling)
l Clean the media (no sand, no sludge)

8. GUARANTEE REGULATIONS

For all manufacturing and material defects, the statutory warranty applies. In these cases we
take the replacement or repair of the device. Shipping costs shall be borne by our company,
except as required by law.
Please report the warranty on our service platform: www.profi-pumpe.de/infor m ation.php.
We will inform you how to proceed with case-related. Returns please sufficient postage.
Unfortunately not prepaid returns can not be accepted because they are filtered out before
delivery. We provide our service in Germany.
Please note that the max. starting current is given by the design of your pump.
It is limited in the inverter to protect the devices. Error: Overload
The max. starting current of the pump must be smaller than the max. permissible inverter
current. Therefore we cannot guarantee the function of any inverter/pump combination.
The warranty does not cover:
l Improper installation (proper installation, unauthorized persons)
l Material wear (e.g. seals) or dirt in the unit
l Unjustified interventions or changes in the device
l Damages by selffault
l Improper servicing and improper use
Moreover, we give no damage compensation for secondary damages!
English 7
[ o] [Ld]